Products

Components we machine every day

We machine to your drawing — these are representative of the work we do rather than a catalogue. Aluminium, copper and steel components for gas-insulated switchgear, transmission and distribution equipment, and the wider engineering sector.

GIS components

Gas-insulated switchgear

Machined aluminium components for gas-insulated switchgear, including plated contact assemblies and large-diameter rings.

Machined aluminium GIS housing — **GIS housing**Aluminium, turned and bored

Aluminium GIS component with silver plating — **GIS component**Aluminium with silver plating

Aluminium ring, 470 mm diameter, for gas-insulated switchgear — **Aluminium ring Ø470**GIS assembly

Silver plated aluminium GIS contact bars — **GIS contact bars**Aluminium with silver plating

Flanges, rings & covers

Rings, covers & flanges

Turned to close tolerance — the bread and butter of our turning centres.

Large machined aluminium flange with bolt circle — **Large flange**Aluminium, faced and drilled

Turned aluminium disc flange — **Turned disc flange**Aluminium, single setup

Pair of machined aluminium flanges of differing diameters — **Aluminium flanges**Matched pair, stepped bore

Aluminium flange with square drive centre and bolt circle — **Drive flange**Aluminium, square drive centre

Machined aluminium flange ring with stepped bore — **Flange ring**Aluminium, stepped bore

Machined ringAluminium, profiled bore

Batch of machined aluminium bush components — **Aluminium components**Batch production

Aluminium profileHELICOIL thread insert

Surface finishes

Delivered fully finished

Through our qualified treatment partners — 7 of 9 within 25 km of the plant, so finishing never becomes your bottleneck.

Aluminium end shield finished with EKU primer — **End shield**EKU primer finish

Painted aluminium flange, 470 mm diameter — **Flange Ø470**Painted to customer spec

Nickel plated machined aluminium clamp components — **Clamp components**Nickel plated

Nickel plated machined aluminium shaft — **Machined shaft**Nickel plated

Also available: silver, nickel, tin and zinc plating · hard and partial anodizing · phosphating · powder coating.

Copper, steel & dead-tank

Beyond aluminium

ETP and tellurium copper components, machined steel parts and dead-tank breaker components.

ETP and tellurium copper machined parts — **Copper parts**ETP & tellurium copper

Machined steel component — **Steel component**Turned and milled

Machined steel block component — **Steel block**Milled to profile

Machined steel rod with threaded end — **Steel rod**Threaded

Dead-tank breaker component — **Dead-tank part**Breaker assembly component

Dead-tank breaker machined ring — **Dead-tank ring**Breaker assembly component

Assemblies

Ready-to-fit sub-assemblies

Clamp sub-assembly

Supplied assembled, tested and ready for the line — components, fasteners and fittings included. You receive one part number instead of nine.

Discuss an assembly

Materials & grades

What we machine, and where it comes from

Raw material only from established mills — and always from your approved sources when you have them. Mill test certificates and full material traceability with every batch.

Aluminium

6000-series rods & seamless tubes — 6061-T6 · 6101-T6 · 6082-T6 · 6063-T6 · 2017-T4 · 5086 F

Copper

ETP & tellurium copper rods and flats · aluminium bronze · brass

Steel

Stainless steel rods · mild steel · alloy steels to spec

Other materials procured to your specification and approved vendor list. Additional grades procured on request against your drawing or standard.

Send us your drawing

We machine to print. Tell us the material, tolerance and volume — we will come back with a quotation and a lead time.

Request a quotation Our facility